Pan/Tilt Invert and Swap
A fixture or a group of fixtures may require the pan and/or tilt to be swapped or inverted. This can be accomplished in the patch by touching or clicking in the “Invert" field of the desired fixtures. A range of fixtures can be selected by clicking and dragging through the “Invert” column.
When the “Invert” field is selected for the desired fixture(s), the following pop-up window will appear:
By default, when patching, all inversions and swaps are set to “off” (Which shows as a blank cell). To invert or swap the pan/tilt on a given fixture, press the corresponding cell(s). Press the soft button to execute the command.
Fixtures that have the pan or tilt swapped or inverted are designated with a “P” for pan inverted, a “T” for tilt inverted or an “S” for pan and tilt swapped or any combination of the three as illustrated below:
