Editing and Deleting Groups

ONYX provides two ways to edit a group.

You can merge fixtures into the group, or you can replace the fixtures in the group with currently selected fixtures.

Merge only adds new contents, while Replace disregards anything previously in the group, and overwrites it with the current selection in the programmer.

To Add or Replace Fixtures in a Group:

1. Select the desired fixture(s) to put in the group.
2. Press Record and the button of the group to change. The following pop-up window appears:
    

To add the selected fixtures to the group, select Merge groups, or to replace the fixtures currently in the group with the selected fixtures, select Replace

You also can Edit Command to make changes in the command line or Cancel Command to clear out the command line.

To Remove a Fixture from a Group:

1. Select the desired group to load it into the Programmer.
2. Press - (minus) xx where xx is the fixture number(s) you wish removed from the group.
3. Press Record and the group number of the original group.
4. Press Replace

Deleting a Group

To delete a group, press the Delete button, then the desired group, and finally Enter. Alternatively, you can press and hold the Delete button and then select a group using the touch screen.

Once all Groups to be deleted are touched, let go of Delete and they will be removed from the grid. Deleted groups are truly gone, so be careful what you delete! Thankfully, ONYX will ask you to confirm any deletion of a group before the command is completed.