Applying Presets

The usual method of applying a preset is touching it on the preset screen after selecting fixtures.

If no fixtures are selected and you press a preset, all fixtures recorded in the preset will become active in the programmer with the preset values. However, no fixtures are selected, so you'll have to select fixtures to begin working with them.

You can also just enter the preset number on the command line after you have selected your fixtures. This can be done with the following syntax:

Step 1: 101 THRU 112 ENTER (More on Selecting Fixtures)

Step 2: @ [Parameter Group Button] [Preset Number] Enter

While that seems a bit complex in writing, it really is as simple as selecting fixtures, pressing the parameter group button (either on screen, or on a ONYX console), then entering the preset number and pressing enter.

Quick Tip: Entering 0 as the preset number loads the default values for that attribute group.